Applications
Demo Path
A practical demo setup that shows the cut, the tooling, and the spec without cluttering the floor.
How Demo Path Walks Through A Cutting-Cell Layout
Demo Path should show a working cutting setup clearly enough for buyers and operators to judge the cut, the tooling, and the specification without unnecessary clutter around the machine. Keep the page focused on what must be seen and what must be recorded.
A Demo Path starts with the stock on the table, the edge quality required, and the machine settings used for the sample. Mild steel sheet, aluminium plate, plastics, and composite panels each need their own note on feed, clamping, and chip or swarf handling. In South Africa, inland dust, coastal air, and power interruptions can change what a clean demonstration actually shows.
Include the opening image of the cell before the first cut is made. That frame should show guarding, tool position, workholding, and the reference marks used for the run. Store a short care note with the demo record so the next operator can repeat the setup without relying on memory after a shutdown or shift change.
Records kept from the demo
End with one usable trail from sample material to finished cut. Record the tool fitted, the pass or cycle time observed, and the defect or handling point being checked during the session. Buyers and operators need one clear account they can compare against later production work.
Link the demo write-up to the relevant "Applications" page and the matching "Edgework" note if the sample includes a secondary finish requirement. Before material leaves the cell, verify the tool ID and the remarks entered on the dispatch copy. Your contact form message should list the machine you run now and the material you want to see cut.
- Sample stock, tool, and cut logged
- Opening cell photo captured before start
- Use the "contact form" for demo details
Site conditions that affect results
A demonstration in Jet Park will not read exactly like one near Durban harbour or Montague Gardens. Air quality, storage conditions, and access around the machine can all influence what is visible in the sample and what must be written down. Where an existing cell is in use, note which parts of the sequence are fixed and which are being tested.
Coastal moisture can mark bare metal samples if they stand too long between cuts and inspection. Highveld dust can obscure guides, sensors, and scale markings during repeated passes. During load-shedding planning, capture the first acceptable article only once the machine has restarted and settled back to the intended settings.
Operated by Astros Marketing (Pty) Ltd from 2 Makro Place, Sunnyrock 1401.
What the Demo Path must show
Brief Demo Path with cell photos, timing, and the cut, tooling, or handling issue the demonstration must answer.
Document the exact point of the demonstration, not every possible variation of the cell. Note whether the session is proving cut quality, tooling wear, material handling, or specification wording for sign-off. Keep the entry with the project file so later decisions can be traced back to the sample that was actually run.
What our Cutting Technology customers say
Verified Google reviews