Specs
Dust Path specs
Setup notes and briefing numbers for Dust Path.
Dust extraction points and checks
The Dust Path specs page records the practical measures used to manage dust around the cutting cell. It covers collection points, cleaning checks, and the areas where build-up affects alignment or edge quality. The aim is a specification the floor can follow without interpretation.
Dust Path specs set out where extraction must pull from the cutting cell and where loose waste tends to settle. They note duct size, hood position, and the machine zones where fine build-up starts to push guides out or mark the cut edge. South African site conditions matter here, especially inland dry dust and coastal air that leaves residue on covers and sensors.
Include a photo of the collection side, the table edge, and the area under the guard before any changes are made. That record ties the spec to the actual machine condition and helps the operator compare later checks against the starting state. A short cleaning note beside the cell is useful where shift handover is verbal and details get lost.
What the spec records
The page fixes the dust route into named points: pickup, transfer, drop-out, and the surfaces that need wiping before alignment is checked. It also records cleaning intervals, inspection spots, and any tooling stations where debris affects plunge depth or side pressure. The wording is kept direct so the workshop can act on it without reinterpreting the intent.
Use this Dust Path entry alongside the matching tooling note and machine setup sheet when dust starts changing cut quality. Before sending details through the contact form, note machine type, extraction arrangement, and where the problem area is. Add whether the issue shows at the spindle, under the table, or at the bin and duct side.
- Pickup points listed by machine zone
- Cleaning checks tied to alignment risk
- Send machine details by contact form
Conditions that change dust behaviour
A shop near OR Tambo may deal with dry airborne dust that travels further into rails and cable tracks. Coastal sites around Durban and Cape Town often see residue cling to covers, filters, and viewing panels, which changes how often cleaning checks are needed. Older buildings and retrofitted extraction runs also affect how well fines move away from the cut zone.
Load-shedding can interrupt extraction cycles and leave dust sitting in the cell before the next run starts. Fine build-up around sensors, stops, and linear guides should be checked before a first-piece inspection, especially after a restart. Where sheet stock sheds heavily, the spec should note bin emptying frequency and the areas under the bed that collect packed waste.
Operated by Astros Marketing (Pty) Ltd from 2 Makro Place, Sunnyrock 1401.
Briefing details
Send photos of the hood, duct route, waste bin, and the surfaces where dust is collecting. State the material being cut, the tooling in use, and whether the problem is edge marking, lost alignment, or blocked extraction.
Keep this record with the machine setup sheet and the maintenance log for the cell. It gives a fixed reference when the same dust issue returns after a tooling change, a filter replacement, or a different material batch.
What our Cutting Technology customers say
Verified Google reviews